This mold is made from soft, tear resistant, very low long term shrinkage silicone. It is great or casting wax, gypsum, resins, concrete and other materials and is heat resistant up to 450°F.
The physical life of the mold depends on how you use it (materials cast, frequency, etc.). Casting abrasive materials such as concrete can quickly erode mold detail, while casting non-abrasive materials (wax) will not affect mold detail. Before storing, the mold can be gently cleaned with a soap solution and rinsed with water. Rubbing the mold repeatedly or with things such as fabric and paper towels can cause scratches to the shine which will cause imperfections in the details. Molds should be stored on a level surface in a cool, dry environment.
Most artists apply heat to pop bubbles in resin once it has been poured, doing this can be harmful to your silicone mold. It can and WILL burn the resin and can damage the mold as well. The resin can burn and fuse to the silicone and if the silicone is damaged, it will cause imperfections in the finished product or cause the heated resin to stick to the silicone mold, damaging the mold itself. If you want to pop the bubbles do so with a torch or heat gun before putting it into the mold.
All molds are made to order, brand new and never used. Once orders are placed, it takes 7-10 business days to process.
Molds are NON returnable/refundable once used. If Mold is damaged prior to use, it may be returned and I will inspect it. If it is determined that it was a defect prior to shipping, mold will be replaced or refunded (minus shipping costs).
in order to make a full 3-D piece, the mold needs to be cut down the side in order to remove the finished piece. Mold can be held together with rubber bands. I provide rubber bands with the order, once rubber bands are used it needs to be replaced, it is the purchasers job to get more rubber bands. Be careful when removing and Demolding finished piece, it is possible for the mold to tear all the way to the bottom if you are not careful. I do not replace molds that tear. So take care when pulling your piece out.
This mold is a full (round) 3D piece. It is NOT flat on the back! There will be 2 small matte circles at the base of the mold to pinpoint where to drill the hole for a Keychain.
Finished piece once demolded will measure 5.25 inches